TM9100
I setup the startup channel on y TM9100 s whenfirst setting it up but I don’t want the one I selected first time as i was not paying attention ans setup a stupid ch.
hi hope someone will help me i am going mad with this vlc thing i can not get it to work and is pis****** off
right i have installed vlcf form edg 4.4 blue button
i have followed the vlc tut to the end but no good linux
this what i have done
installed vlcf on tm9100
installed vlc 081 from tut
changed icon with the extraintf
altered vlc xml to 192.168.1.###
start dir to l:
copied to var/tuxbox/config
copied vlc.cfg and vlc.so to var/tuxbox/plugin and chmod 755 both files
saved and rebooted box
started vlc with new icon on pc
on tm gone to yellow button pressed videolan and box just locks up so reboot box and tried vlc front end and box just cycles through and back to tv
so i gues my box is not seeing my pc running vlc?
my pc is on wireless connection and i turned firewall off
i kept the user as admin and pass as admin in xml file and i did try it with my log in name and pass but still no good if anyone could help me i would be very greatfull
My question tho might sound stupid as I have looked everywhere to reset it but can anyone tell how or is there a DOC that is downloadable to give these options as I seem to find new ones every time I use it.
Posted by: admin 
Category: Uncategorized 
Multimedia Center running on Enigma
Linux Home Multimedia Center running on Enigma + PVR Ready + 9in1 Memory Card Reader + Ethernet Communication Port + Unlimited Channel Memory + 2x Smart Card Readers + 1x Common Interface (CI) + 72MB SDRAM + 16MB Flash
Tech Spec
* Fully DVB compliant
* Linux open source ; Standard Linux API
* Getting various Linux applications
* 252MHz IBM PowerPC Processor (350MIPS)
* Internal Hard Drive (HDD) support for PVR
* Multi-Slot Flash Memory Card: SD, Olympus, Memory Stick, MMC, Smart Media Card etc. supported
* 10/100M Ethernet interface
* 72MB SDRAM Memory (64MB for Software Memory + 8MB for Hardware Memory)
* 16MB Flash Memory
* 2x Smart card slots
* S/PDIF interface (Optical & Coaxial) for Dolby bit stream out
* Sharp Tuner (2~45 Msps, SCPC scan)
* 1x Common Interface (CI) slot
* Firmware/Software upgrade through: Serial (RS232C), Memory Card, Ethernet & Internet
* Unlimited TV/Radio channel storage
* Very quick channel change time ; < 1 second
* Support multiple LNB switching control (DiSEqC 1.0, 1.1 & 1.2)
* Full automatic satellite/service scan
* Smart Electronic Program Guide (EPG)
* OSD & VBI Teletext
* Variable aspect ratio (4:3, 16:9)
* 24 OSD Language menu
* Programmable event timer
* Subtitle
* Parental Control
* C & Ku band reception
* Video Out: RGB, CVBS, S-Video & YPbPr selectable
The Technomate 9100 comes in 2 flavours. The original 9100 and the 9100 Super which has more memory
TM-9100
Technomate TM-9100 Super; Technomate’s first Linux based Ethernet connection satellite receiver. You must know what you doing with this receiver otherwise i do not recommend you to get one. You can do anything with this receiver: share applications from someone with Ethernet or get someone else ip address and connect the two receivers each other